Charging the Battery
The EasyStand Bantam Medium Pow’r Up Lift uses two 12-volt sealed lead batteries rated at 2.9 amps
each. An EasyStand Bantam Medium can be lifted approximately 100 times on one full battery charge.
An audible alarm will sound when the battery is low. Please charge the battery after the alarm sounds.
A battery needing to be fully recharged will take approximately 8 hours. The EasyStand Bantam
Medium can be raised to the standing position while being charged. The function of the charger is to
detect a full battery and then provide a constant potential power supply to hold the battery at a full
condition without overcharging. When the battery EMF rises to a factory preset point,
the charger circuit will not allow the peak output voltage to exceed that
value. This factory setting protects a battery from excessive depletion of
electrolyte, which can occur from overcharging. The charger can be found
in the tool pouch on the back of the unit.
CAUTION: Use only the Linak charger, model numbers 00CH01-XX OR
10CH01S-00, provided by Altimate Medical with the Pow’r Up option.
1. Plug the receptacle into a wall outlet. The light on the charger will be
green indicating an open circuit.
2. FIG. A- Plug the charger cord into the side of the hand control. The light
on the charger will turn yellow indicating the batteries are being charged.
3. FIG. B- The unit will arrive unplugged from the battery, plug in the
white cord that supplies power to the actuator and the black cord that
supplies power to the remote. The black cord has a notch on it to orient the
connector properly. Fully charge battery before use.
Note: The white cord has a rubber washer on it, which makes it very sticky
and sometimes will not get pushed in completely, make sure to push the cord all the way into the
battery.
4. When the batteries are charged, the light on the charger will turn green.
5. Fully charge the batteries every three months or less during periods of
intermittent or non-use.
CAUTION: The Bantam Medium Pow’r Up Option is not designed for
continuous use. Duty Cycle 5% Max, 1 min. / 19 min.
Raising the Lift - Press the UP (arrow up) button on the hand control to
lift the seat.
Lowering the Lift - Press the DOWN (arrow down) button on the hand
control to lower the seat.
CAUTION: Ensure the cables are attached properly per the instructions for use. Do not allow the cables
to drag on the floor or to catch on objects.
Pow’r Up Lift Option Usage
FIG. A
FIG. B
!
!
!
The hand pendant is a
Type BF applied part.
Pow’r Up Option
Page 25
(6 pagine)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale